|
|
Post by tacoboy8296 on May 17, 2006 15:06:56 GMT -5
This is to replace your rear window relays with some easy to find relays from the parts store. u can find the relay behind the drivers side panel just past the door. It should be the gray box.  |
|
|
|
Post by mudwiser316 on May 17, 2006 23:12:51 GMT -5
i've needed this for about 5 months! i'm good with wiring but this looks like a challenge. i hope your right i would not want to f**k these wires up. i'll give it a try! what does the M mean that wires 1 and 3 connect to! thanks!
|
|
|
|
Post by tacoboy8296 on May 21, 2006 22:53:32 GMT -5
the rear window motor. It still goes though the fatory swiches. It's how i have mine is wired here is the fatory diagram i used to make mine.  |
|
|
|
Post by mudwiser316 on May 21, 2006 23:24:37 GMT -5
once i look at the factory diagram i got it. thanks! i must say your diagram is a lot easier to understand!
|
|
|
|
Post by tacoboy8296 on May 23, 2006 12:25:59 GMT -5
|
|
bomrbe
Junior Member
Posts: 64
|
Post by bomrbe on May 23, 2006 21:08:05 GMT -5
jw....and i havent payed much attention...but how much would it cost to fix the relay?
|
|
|
|
Post by mudwiser316 on May 23, 2006 22:24:03 GMT -5
this might seem like a dumb ? but with this set up does it or will affect the rear window wiper! i figure not but at the same time i figure i would ask. thanks!
as i look at the pic's you posted and i see the bare wires that have already be soldiered do you plan to cover them or as i would have done put some heat shrink over the bare wires. just wondering!!! later!
|
|
|
|
Post by tacoboy8296 on May 26, 2006 12:00:01 GMT -5
I just used silcone sealer and wrapped it with tape till it dried. If u do this mod ur rear window will not work. because it get it power though one of the relays on that u will be removing. but there is a way to add anthere relay and make it work again. I just haven't have the time to find out how. If i have time this weekend i will look in to it. I am not sure on the cost of fixing the old relays but i spent around $10 dollars on my set up. I was able to find some locally. but here is a web page u can order them from: www.partsexpress.com/pe/showdetl.cfm?&DID=7&Partnumber=330-070www.partsexpress.com/pe/showdetl.cfm?Partnumber=330-073They also have wiring harness u could buy if u want. Just make sure the relay u buy has the 87 and 87a pins because some of them have two 87 pins these will not work. u will melt some wiring if u use one of these relays. So look closely at the bottom or side of the relay it should say if not sure i wouldnt use it. U can also use a meter to check the conection beteen pin 87 and 87a should be open at all times. The reason u don't want to bypass the relay is because the factory rocker switch wasn't ment to handle the load of the window motor and will burn up over time. thats why they use relays to take the load off of the switch. Here is a good wire up on fixing the rearwindow and will answer any questions u might have. www.4crawler.com/4x4/CheapTricks/RearWindow.shtml |
|
|
|
Post by Pliska on Feb 23, 2007 16:32:02 GMT -5
I just bought 1990 4RUNNER 2.5TD. It is in a good condition in general, but one of the few little problems is that I can't open the rear window from outside with the key and if I have to opoen the back door, first I take the back window down with the inside button and then I go out to open the door. Could you please send me the fatory diagram for 1990 model so I can try to fix it.
Thanks!
|
|
|
|
Post by tacoboy8296 on Mar 28, 2007 21:39:15 GMT -5
here is a diagram for newer runners  |
|
|
|
Post by bucketofbolts on Apr 23, 2007 0:10:12 GMT -5
my back window try to roll its self up when it already rolled up. it drains my batt in like 2 hours i disconnected it but would like it to work any advice?
|
|
|
|
Post by tacoboy8296 on Apr 27, 2007 18:27:40 GMT -5
sounds like a relay is stuck u will have to replace it. When u let off the button it should click if it don't it's stuck. It could be rusted in rust in side.
|
|
|
|
Post by mississippimud on Apr 27, 2007 21:10:22 GMT -5
agrees with tacoboy, more likely relay stuck.. check for a draw on you battery with the relay in and also with it out, if the draw goes away with relay out replace realy, if not you have wire somewhere corrupting your circut.
later
|
|
|
|
Post by bucketofbolts on May 11, 2007 18:35:22 GMT -5
my back window stopped roling up or down and it would drain my battery in 2 hours. i replaced both relays and nothing i dont know whats wrong is there a fuse some where i need help real bad
|
|
|
|
Post by tacoboy8296 on May 22, 2007 14:20:19 GMT -5
the gray box has relays in it to and one of them is stuck. try changing it or just unplugging it and ur batt. should stop draining.
|
|
|
|
Post by bucketofbolts on May 28, 2007 13:26:24 GMT -5
i did unplugg and it stopped draining my batt but i wanted to take the top off my 4runner so i just pulled the motor out a little and it let the gears loose and my window is down now but im gonna want it back on eventually should i just try to find a whole different tailgate to replace mine?
|
|
mock1
Full Member
Posts: 212
|
Post by mock1 on Jun 3, 2007 22:24:43 GMT -5
the motor for the tailgate window is that same as all the other motors used in 2nd generation 4runners and trucks, so they are easy to find. and the rails and regulater stuff they usually sell on ebay for pretty cheap. it seems like a better idea then a whole new tailgate. my .02cents
mock1
|
|
|
|
Post by tacoboy8296 on Jun 11, 2007 13:36:13 GMT -5
I think the motor is the same as one of the front windows cann't remember which side but just the motor.
|
|
|
|
Post by greedsclf on Sept 27, 2007 18:05:12 GMT -5
so can anyone tell me where the circuit breaker shown in the diagram is in the truck
|
|
