Hub Rebuild?

[DrumBum]

ok, so i was out workin on my rig a little bit today, and found out that the right front hub is stuck locked. the dial will turn with some force, but it stays locked up.
so, my question, where can i get a rebuild kit, or whatever i need to fix it? i tried searching, but didn't come up with anything. i did take it apart a little to see if anything was stuck, and it looked ok to me, but then again, i don't know what it's s'posed to look like... it was kinda crusty and stuff, tho, so i figure it'd be worth it to rebuild em both...
anyway, sorry for the long post, and thanks for any info/parts sources you guys have run across!

[kjmcdaniel]

You probably don't need to replace any parts. Just take it apart, clean it up, put some silicone grease on all the moving parts (ie. the dial, the spring, the groove on the inner spline that moves in and out when you turn the dial.) Be carefull not to loose the little detent ball, and spring. Also, be sure the hub is in the unlocked position when you remove the dial. It will be easier.

[Shibby24]

Donno if this helps or not...But when I took my hubs apart to replace stuff, when assembling them I had the turn dial/spring stuff slight off (got turned a little when I was cleaning it, was really dirty in there : so when put back in it wouldnt turn all the way, making it so I couldnt engage the hubs, not sure if this could somehow leave it locked or not, but a good cleaning, as kjmcdaniel said is what I would do, made my hubs turn easier