|
|
Post by dybgpn on Apr 15, 2008 20:12:39 GMT -5
Will 33x10.50s BFG ATs on stock aluminun 15x7 wheels fit with only a 1" body lift on my 87 X-tra cab?
|
|
|
|
Post by yotanut7 on Apr 15, 2008 21:30:45 GMT -5
Yes. They would probably fit without the lift. BUT, expect rubbing even with the lift. I had 31's on 15x6 stock steel wheels on my 87 and they rubbed just a little on the frame at full lock and full stuff. It looked like there was plenty of room for a bigger tire and I have no lift. You might try the tires before the lift. I imagine the tires are going to rub on the frame before they hit the body.
|
|
|
|
Post by Hoodlum on Apr 21, 2008 10:46:04 GMT -5
4xfred ran this set-up. As far as I remember he had to crank the torsion bars a little bit and with the 1" BL. I don't think his tires rubbed at all after that.
|
|
|
|
Post by 94cnytoy on Apr 21, 2008 18:04:03 GMT -5
Watch out for the body seam inside the fender wells.
( driver and passenger side of the tub itself )
Pound it over with a BFH and undercoat any exposed steel.
Also watch the front bumper at full lock ( l & r ) may need little trimming.
Also....the rear fender well could slice at full tilt too.
Lifting the tire or axle side alone may not show you enough.
I sliced up a set of swampers quite well.
Stew
|
|
|
|
Post by yotapowa on Sept 21, 2008 23:48:03 GMT -5
I clear 32s with no lift with very minimal rub on the front tires
|
|
|
|
Post by yotapowa on Oct 3, 2008 14:43:21 GMT -5
except my bumper end caps are MIA
|
|
