dkm
New Member
Posts: 1
|
Post by dkm on May 31, 2004 1:27:12 GMT -5
how do i program a keyless remote for my '00 4runner?
i see many for sale on ebay. is there a specific model i have to buy?
|
|
GunManOsh
New Member
Fight the good fight.
Posts: 48
|
Post by GunManOsh on Sept 1, 2005 17:33:06 GMT -5
I'm curious about this one as well
|
|
|
|
Post by spaber05 on Jul 28, 2006 20:26:44 GMT -5
I found some very reasonably priced remotes for my '01 at www.keylessremotesforless.comthey came with instructions which at first, were a little tricky, but once you got the hang of it, it went fine. They had most Toyota models so chances are yours would be in there. Hope this helps. |
|
|
|
Post by 4runnerdna on Sept 1, 2006 20:58:52 GMT -5
Heres a few instructions to look at..
If you have 2 remotes make sure you have both remotes ready.
open drivers side door
stick the key in the ignition then pull it out
lock and unlock the door 5 times (that's 10 times that you have to press the button) It should be completed with door unlocked.
shut and then open the door
lock and unlock the door 5 times(that's 10 times that you have to press the button) It should be completed with door unlocked.
stick the key in the ignition and turn to on then off then on then off
pull the key out of the ignition
you should hear the door locks go lock\unlock twice
press the two top buttons on the remote for 1 second
then press the unlock button by itself for 1 second, timing may vary
Now for the second remote,
press the two top buttons on the remote for 1 second, then press the unlock button by itself for 1 second. You should then hear one unlock\lock indicating success. If you hear two unlock\locks then you have to start over. After you have completed the program of both remotes, put the key in the ignition and pull it out. Your remotes are now programmed.
|
|
