|
|
Post by blue1985yota on May 17, 2004 21:28:04 GMT -5
due to my pops rules i need a bucket seat, 5 point harness and a roll cage for my truck before i can drive it, i turn 16 reall soon. were can i get this stuff thats good but cheap?
|
|
drewbond
Junior Member
1987 Supra Turbo
Posts: 54
|
Post by drewbond on May 17, 2004 23:38:57 GMT -5
When the word safety comes in to play, cheap hardly follows. Best option would be summitracing.com you can find the 5-point and the seat there, the roll cage might have to be custom fabbed. I wouldn't buy a used seat belt unless you can inspect it for cuts or other damage. If it is damaged just walk away from it. I have a welder and about 100 feet of square tubing if you need help with the cage, could make a cool exo-roll cage.
Note: with any 5-point harnass, the shoulder straps should never be bolted below your shoulders, even for temp use, if you get in to the smallest wreak and it was bolted below your shoulders, the straps would cause your spine to be compacted
|
|
|
|
Post by DrumBum on May 18, 2004 1:01:24 GMT -5
|
|
|
|
Post by ToyotaMike on May 18, 2004 14:53:39 GMT -5
Also might want to check out jegs.com or go to your local gi joes. They sell apc racing buckets for $150 or hell if your near auburn I got a set of SR5 stock buckets you can have for $10. Also if your in this area Honest Performance in Federal Way sells harnesses for a resonable price.
|
|
|
|
Post by blue1985yota on May 18, 2004 23:12:55 GMT -5
Thanks for the help, i will either be getting the seats from gijoes, ive seen them before, of Corbeau Baja SS. still got some more questions.
does gijoes sell brackets that will fit into the pre-existing holes or will i have to drill new ones?
exo-cage is a cage that goes around the out side of the cage right?
and how much will you charge for building me a cage?
|
|
|
|
Post by blue1985yota on May 18, 2004 23:16:30 GMT -5
On a 5 point Harness, were do the lap belts mount if they need to be on the frame or roll cage liek the shoulder ones?
|
|
nate650
Full Member
don't let yesterday use up to much of today
Posts: 114
|
Post by nate650 on May 19, 2004 0:19:48 GMT -5
They usually just mount through the floor with an eye bolt and a large washer.
|
|
drewbond
Junior Member
1987 Supra Turbo
Posts: 54
|
Post by drewbond on May 19, 2004 9:18:38 GMT -5
and how much will you charge for building me a cage? an exo-cage would be made on the out side of the truck if you just want a roll bar on the out side of truck between the cab and the bed about 100 to 200 if you want to get more detailed describe where you want all the bars, like fender protection, or a bumper grill |
|
|
|
Post by blue1985yota on May 22, 2004 22:58:10 GMT -5
The cage would be a in-cab cage.
|
|
