|
|
Post by orangeyota on Apr 26, 2008 23:25:34 GMT -5
i was wondering what all i need to put a set of Chevy 3/4 ton axles under my 81 yota. any info would be nice.
|
|
rsdan
Full Member
Posts: 116
|
Post by rsdan on Apr 27, 2008 0:38:13 GMT -5
Um...chevy running gear setup, moving your spring hangers back, better gears, better motor. That's about it. I built up my motor and I am swapping all my running gear out for a D44 front and 14 bolt rear, Chevy 6 inch lift springs, Front two inch spring hanger lift, 2 inch rear blocks, and two inch lift shackles front and rear. Going with the ssr's for rubber and a 3 inch body lift. Be prepared for alot of work....
|
|
|
|
Post by stice316 on May 10, 2008 8:53:41 GMT -5
if you want an easy way to make your stance about a foot wider that is the way to go. next you will run into what to do with the steering, break lines, and master cylinder That was as far as i looked in to it and just put 63" springs in the rear with stock Toyota axles. Does great with 35s now going to see how they hold up on 38s
|
|
