|
|
Post by dirtyrice on Mar 12, 2009 18:02:48 GMT -5
I have just got done with my auto to manual swap but i have a problem the clutch willnot disingage so i cant put it in gear i have bled to slave cyl. that didnt help i even toke the trans back out to see if something was wrong in the bell housing put it back in and still the same problem  any help would be great o also it already has new slave cyl. and master cyl. just old lines |
|
|
|
Post by Sean on Mar 12, 2009 19:18:09 GMT -5
Is the slave moving? Measure the throw of the slave cylinder. You could easily have the plate in backwards. If you find the slave is moving the proper distance then that is likely your problem. Otherwise look upstream. Is the pedal fully depressing the master? ect.
|
|
|
|
Post by fourwd1 on Mar 12, 2009 20:16:20 GMT -5
I've seen people put the fork in wrong too.
|
|
|
|
Post by dirtyrice on Mar 13, 2009 12:45:19 GMT -5
the slave is moving but how far is it supose to move and i looked at the clutch plate im pretty sure its in right the centerforce site said the red side go's to the fly wheel could the rubber hose be clapsed in side and not letting enuff fluid threw
|
|
