|
|
Post by orangeyota on Apr 2, 2009 9:46:14 GMT -5
hey guys i got a 93 toyota pickup 4x4 with the 22re, it resently blew a head gasket so i took the head off and sent it to the machine shop well it come back as cracked so i orded me a new complete head but its stock so i want to upgrade the cam to one that has good low and mid range power witch cam would be a good chouce the engineBLDR 268 torq or the high torq cam from north west off road?
my driving conditions are mostly high way but some city, and i pull a trailer, some off roading. and the mods ive got on the truck are a cat back flowmaster exhaust, the squar to round adapter with a high flow filter and 32/1150/15 tires
|
|
|
|
Post by mudwiser316 on May 11, 2009 16:52:20 GMT -5
I was just wondering what you where going to do with the stock cam? As for which cam to go with i'm not sure! I put the big one from NWOR in my 93 twd but I didn't see any improvement. I went for top end and not for low end performance. Just my $.02. Later!
|
|
|
|
Post by whomadewho on May 12, 2009 10:54:16 GMT -5
Research your cam options carefully. Contact different cam MFG. You are VERY LIMITED in choice with fuel injected engines. I went with a mild cam and I WISH I hadnt. It changes the air fuel mixture and makes getting the engine to idle half way decent difficult. Also read up on proper cam break in. If your really looking to do a build up,you may want to go with a carb set up.
|
|
|
|
Post by orangeyota on Jun 14, 2009 22:16:37 GMT -5
well i no its been a few months but not long after i posted this i got my engine back together. as for my cam i went with the enginebldr 261 crawler cam. i did notice a little power gane but not much. if i would have to do it again i would not worry about putting a performance cam in, it was just a waste of money if you ask me. like stated above it was a bitch to get the engine to idle half way descent .
|
|
